So I Made Some Cute Lil Iridescent Soda-bubble-aesthetic / Starry-sky Lookin Eyes N Decided To Make A

always thought chuck’s old walkaround was cute in a frumpy way

Thank you so much! I’ve been painting my furby Tumbleweed and this post is super helpful!

tips for furby customisation for anyone new to it:

i cannot stress enough the importance of paint primer and a sealant.

y'see, because the plastic is so incredibly smooth, there's nothing for the paint to grip to and it just wants to slide off and chip away

with primer it gives the paint something to hold on to and sealant does what it's named after, it seals the paint in with a protective layer to prevent chipping!

it can also give either a matte or shiny finish depending on which sealant you use and which you want to use

my reccomended primers are:

professional primers from craft stores (idk any) or just a thin layer of pva glue (liquid form)

reccomended sealants are:

craft store sealants or mod podge which has a matte or shiny option

I love this beast. if you want to see more images of him simply search for his name: the campy bara. you wont be disappointed

🌟 1998 Furby Re-Lashing Guide 🌟

A visual step-by-step guide to my own process for giving 1998 Furbies lashes that retain the classic look. There may be other guides and methods out there, this is just my own way to do it!

MATERIALS NEEDED:

Detached Eyelids ( guide for removal: CLICK HERE )

13mm D-Curl Lash Extensions ( see photo )*

Mod Podge

Tacky Glue

X-Acto Knife

Small Paint Brush

Q-tip

Lightweight Paper

SHARP Scissors

Clean Water

Washcloth or Paper Towel

Optional, Ruler with cm/mm marks & Marker or Pen * 13mm will be closest to original length, I would not recommend anything longer than 15mm unless you want the lashes to really look insanely long.

I will put all of the steps under the readmore! 👇

Step 1:

Use the x-acto knife to gently peel up an eyelash foil strip, and be careful not to disturb the lashes. Go slowly and only handle the strip by the sticky foil. You will only need one strip for a pair of lashes!

Step 2:

Place the sticky strip on the lightweight paper, I put it close to the edge because it'll be easier to cut out later. Paint a thin layer of Mod Podge over the base of the lashes on the strip to secure them. This is an important step, there isn't much else keeping them in place, otherwise!

It's hard to wait, but let the glue dry before handling the strip again, I suggest a good 30 minutes or so.

Step 3:

Now that the glue has dried, cut out the paper around the strip and very carefully trim the foil and paper at the sides and underneath the curl of the lashes. Do this slowly, so you don't accidentally snip the lashes, you ONLY want to trim back the paper+foil. This will make them appear more flush with the eyelid when glued in.

Step 4:

Optionally, use a ruler to find the center of the strip and mark it with a marker, I used a Sharpie because it dries instantly. It's possible to eyeball this, but I like them to be as even as possible.

Snip the strip in half, very sharp scissors will prevent the foil from bending or warping. Again, be careful not to snip the lashes themselves! It's ok if you lose one or two in this process, as long as they still look relatively clean and even once split.

Step 5:

Apply a drop of tacky glue to the back of each eyelid and use the Q-tip to spread it in a thin, sticky layer. The eyelids have a little trench you can use as a guide for placement.

You can repeat this process if you wish with the top of the lash strip where it will be applied, as well, to make it stick better. I haven't tried this myself, yet.

Place the base of the lash strip over the tacky glue and press it into position, I use the backs of my thumb nails to hold them firmly while the glue sets. It make take some effort and patience to get them to stay in the curve, just try not to slide them around.

Step 6 (Final):

After the tacky glue has had some time to dry, I like to apply a final coat of Mod Podge over the paper and underside of the eyelids to seal and protect everything. Give this 30 minutes to an hour to fully dry before re-assembling your Furby!

✨ Voila! Fresh new eyelashes! ✨

They won't look exactly like the original, but close enough for me. I'm sure the process can be improved in some ways, so if you have any feedback please share it in comments or tags!

Good luck with your projects and thank you for reading! 🌟

Can we talk about how bad the Rae market has become? Like why is a single plushie $100+ and why is an animatronic needing 5k+ in restoration work being sold for $7k?

I totally understand that it’s because of things like inflation, demand and not many to go around but like. UGH. My wallet hurts. Why wasn’t I investing in this shit in 2002 before I was born and everything was cheap. SMH.

Thank you to everyone who informed me that hair needs to be washed multiple times in one shower, My hair hasn’t felt smooth in like…maybe years. I can run my fingers through it without it getting stuck and it doesn’t feel as heavy on my neck. This is great. Why did no one ever tell me this before?

support trans people.

Welcome

I would be truly grateful if you could help me with a donation in order to save my children and my family from the dangers of war and death in Gaza and escape to a safe place

Please Share Or Replog Or Donate For My Family 🙏

https://gofund.me/0511f253

This is a vetted fundraiser, verified by 3 different blogs. Please donate if you can!

gofundme.com

Doneer aan Help us build new hope for me and my family, georganiseerd door Safa'a Abd

Hello world I'm Safaa, 25 years old, the wife of the best man in the w… Safa'a Abd heeft je hulp nodig voor Help us build new hope fo

It was raining outside, so I took a photo indoors instead.

The Great Pizza Show!